In general, depending on the structure and your purpose of that building, each type of reinforcement is different. Here are its steps.
🔹 🔹 🔹 🔹 مین مان مان
Before doing anything, a mock-up and its map must be drawn.
🔹 ن Buy rebar 5
They usually use simple rebars for small projects. For larger projects, according to the type of use of that structure, the type of rebar should be purchased.
🔹 🔹 🔹 🔹 🔹 مان Consultation and Drawing of the Copper
After buying and ordering the rebars, you should consult with the supervising engineer according to your purpose of the structure. This supervisor usually checks the size and type of rebars. And according to the difficulty or simplicity of your project, it guides the operation.
🔹 🔹 🔹 🔹 🔹 🔹 🔹 🔹 🔹 🔹 مان
According to the specific type of each concrete structure, there are different methods for bending rebar and reinforcement. This case, which method should be used, is usually a matter of taste, and the builder and the person who closes the reinforcements use 3 regular methods, the tie method and the knotting method according to their taste. Welding is not usually used for reinforcement. Because due to welding, the surface loses its smoothness and uniformity, and it may break due to the application of force.
🔹 🔹 ما How to place reinforcement
One of the most important stages of reinforcement is how to place the reinforcement in the concrete structure. You definitely need an experienced person to guide you in this matter. They usually use large rebars for tall columns.
🔹 🔹 🔹 🔹 🔹 🔹 🔹 🔹 🔹 🔹 🔹 ما
Most design engineers and supervising engineers emphasize on this stage. Because it needs checking not once and again, but checking the reinforcement several times before concreting. The most important thing to note is that usually the armatures cause damage and problems during moving. When walking on the armatures it is determined whether it needs to be rewired or not.
🔹 🔹 🔹 🔹 مری مان
For the last step of reinforcement, you need to place the mold and pour concrete around it. They usually use metal molds in the molding problem. The shapes of the molds are different and they can be used to form cylindrical columns.
