1. Preparation of parts: Before using the device, make sure that the wooden surfaces are clean, smooth and free of any contamination. This helps with better adhesion.

2. Choosing the right glue: The type of glue you use is very important. For wood, special wood glues are usually used, which have good drying time and adhesive strength. 3. Applying proper pressure: When pressing, the pressure should be enough for the glue to work well, but avoid too much pressure that may damage the wood. 4. Pressing time: Pay attention to the time required for pressing. Usually, depending on the type of adhesive, there is a specific pressing time that must be followed. 5. Uniform pressing: Ensure that pressure is applied evenly over the entire surface of the wood to create uniform and tight joints. 6. Checking and adjusting: After pressing, check whether the parts are properly attached. You can press again if needed. 7. Attention to safety: Always use safety equipment such as glasses and gloves to prevent possible injuries. By following these tips, you can make the most of your woodworking press and get better results in your woodworking projects.