If when you touch different parts of the radiator and heaters, you notice that some parts are heated and others are cold, it is most likely due to the air in the path of the radiator, hot water is evenly distributed to all. Parts are not distributed. Therefore, after some time, you will notice that the efficiency of the package has decreased.
The reasons for the clump of the package you need to know
The continuous air intake of the radiator package can have various reasons. In the following, we will mention several reasons for the presence of air in the package.
- If the pipes inside the heater or the pipes that are stretched from the package to the heater are leaking, there is a possibility that the air is leaking from them. It penetrates slowly and affects the heating efficiency, it goes up a lot. Therefore, we recommend that you take this problem seriously and repair the holes as soon as possible.
- If the water flowing in the system is emptied, the possibility of air entering the system increases.
>- If due to connection to city water that has a lot of salts, the pipes get rusted or absorb sediment on the piping route from the source to the radiators, there is a possibility of air infiltration inside the package.
< p>- If there is aluminum in the pipeline to the radiators, their corrosion is not far off; Because aluminum corrosion produces hydrogen gas. The release of this gas causes air to appear and disrupt the work of the package system.- Another reason for improper operation of the radiator is the failure of the heating system sensor and the radiator not being activated or being activated. It is at an inappropriate temperature. If the gas pressure drops due to a leak in the package system, the engine temperature will definitely rise and the radiator will not function properly. As the last reason for the presence of air in the package system, we should mention the sedimentation of the converter. The presence of sediment in this part causes the heat transfer not to be carried out properly and increases the temperature of the engine.
How is radiator ventilation done? How often do you have to do this?
Airing refers to the steps that are taken to remove the air and replace it with hot water. After these steps, hot water distribution is done uniformly. If this question arises for you that you should do this once in a while, we must say that in systems where the central heating system and heaters do not have any particular problems, it is not recommended more than once a year. But you may sometimes have to air the package in the winter season. Remember to solve the problem of continuous air intake of the radiator package as soon as possible.
- To start airing the package, you must first turn it off so that no more air enters the heating radiator pipes.
- Now you have to open all radiator valves.
- Due to the importance of this issue, a special valve for air discharge is installed in the upper and lower part of the radiator, which must be opened by a special screw or in new devices. It can be opened with the help of a lever, screwdriver, or French key.
- To prevent the floor from getting wet, you must place a special container under the faucet so that water and air can escape from it. Wait for a while until all the accompanying weather is emptied.