Introducing types of domestic water pumps

When we talk about a domestic water pump, it means that this pump is intended for domestic use and is different from industrial water pumps and agricultural water pumps. The amount of consumption in homes is almost to the extent that these household water pumps will be sufficient for this type of consumption. We will see the types of domestic water pumps below:

The one-horse water pump is one of the most common and widely used domestic water pumps, which is used for various purposes, especially for domestic purposes, along with the half-horse water pump. This type of water pump is usually found in the market in two types: a plate horse water pump or a jet horse water pump. The application of each of these pumps is different and is chosen depending on the place where the pump should be used. This type of home pump can be used for three- to four-story buildings with an area of ​​about 70 meters. We suggest you read the article on the best water pump for a horse.

A plate water pump with the ability to throw high water can raise water on the surface. Plate water pump is the most common type of water pump in high-rise buildings. This type of water pump, which is also used in agriculture due to its function, has a lower water suction power compared to the jet type and is more suitable for domestic use. Because in most cases, water in homes reaches the pump through a source or surface pipes.

The jet water pump is mostly used in cases where there is a need to suck water from deep. This pump with very high suction power can pull water up from the lower parts. For this reason, a jet water pump is used to pump water from the depth of the well. Of course, this pump has special household uses that are getting more attention day by day. One-horse jet water pump can be used for one- to four-story buildings. Read the full description of how to choose the right water pump for the building in the Alborzmakhz articles section.

Regarding the construction and development of skyscrapers in urban spaces, water supply to upper floors is one of the challenges that most buildings face. Various solutions are considered for designing a water supply network in these buildings, one of which is the use of a home booster pump. But in another type of designing the water supply system to the upper floors, a method is used in which water is sucked and pumped by two different pumps in the floors.

Supposing a thirty-story tower to supply water to the upper floors can have a source for storing water on every ten floors and a plate pump for pumping to the ten floors above it. In this situation, there is a need for a jet water pump to suck water into the sources of each floor to bring water from the ground floor to the upper floors.

In some cases, the jet water pump is also used in the mode of placing it on the surface, which is naturally less powerful than the plate water pump.

Centrifugal pump with a simple and practical structure is used in different conditions. Centrifugal water pump is used for things like circulator pump and permanent water supply system. This pump is in the dynamic water pump category and is used for various purposes.

Nowadays, in every building that uses a heating house or a package, there is at least one type of centrifugal water pump. Naturally, a smaller pump is placed in the packages, which do not differ much in terms of performance from the models used in the engine room. In fact, the use of this type of pump is to continuously circulate water in heating systems.

Water pump with expansion tank or water pump with pressurized source, generally one horse pumps are called, which are used to strengthen the pressure power and also measure the amount of pressure in the water supply system inside the pipes. In order for the pressure in the pipes not to be too high to damage the piping system, it is necessary to turn off the pump at times. This should be done automatically without manual intervention. One of the things that the expansion tank or pressure source in home water pumps do is actually inform the pump that it should be turned off or on, which happens through the pressure inside the source and the pressure switch.