cooling

Cooling means:

🌀 "creating suitable conditions to reduce the temperature of a place (or a substance) compared to its environment" in other words the definition of refrigeration "The transfer of heat from an environment with a low temperature to an environment with a higher temperature." Cooling can be classified from several points of view:

Inner Unit: This section is installed inside the building and is responsible for distributing cool or warm air. The inner unit usually contains a fan and evaporating coils.

Outdoor Unit: This section is installed outside the building and includes compressor, condenser and fan. The external unit is responsible for the heat transfer from the inside and vice versa.

The benefits of Split Cooler

A classification of basic cooling methods is as follows:

1- Open circuit cooling 2- Closed circuit cooling 3- Cooling by special methods 🌀 There are other methods for cooling, some of which have low efficiency and some are used for low temperature systems. The most famous of these systems are thermoelectric cooling, magnetic cooling, optical cooling and heat-acoustic cooling.

نکات مهم در خرید کولر گازی اسپیلت

Types of gas cooler

Single Panel Split Split Cooler

Split Panel (Multi Split)

Portable Cooler

Window Cooler

Standing Gas Cooler

Split)

Casting Curly Cooler

Updated and modern systems including VRF, MDV, DVM

The difference between the water cooler and the gas cooler

How to install the air conditioner

Installation of a tray to hold the internal unit on the wall: To install the tray, a tray needs to be mounted on the wall and uses a special drill and drill for drilling on the wall, as well as installing a remote control holder on the wall in a place where it is easy to install. Land or sloping ceilings.

Installation of a suitable fuse type of work fuse (motor fuse) as well as the use of standard and high quality cable to suit the device's consumed current where the ground connection system is present. Make sure to connect the device's wire.

When installing the internal and external uniform, the standard length of the plumbing is provided from the moments of the pipes and the entire length of the pipes.

When the external unit (condensing unit) is higher than the internal unit, the oil flows into the plumbing path. To make it easy to make or install an oil trap for every 1 to 2 meters of internal and external units.