Package Torch
The cause of the burner not turning on, which is the first common problem of the wall package + its solution known from the Allopiping team, can be related to many reasons. Such as fluctuations in water or electricity pressure, there is a problem with the gas inlet, air pressure failure. Also, the lack of gas pressure can be one of the reasons for this problem. What is the solution? You can make up for the lack of water pressure by using a surge protector. Change the gas inlet valve, change the air pressure switch, you can also contact the gas department.
Not working the wall package
This problem can happen because the package's input power is cut off. The wiring connection is defective, the pump is burnt or damaged. Also, the connection of the internal wiring may have been damaged. What should be done now? Check the outlet, internal wiring and fuse. Regarding the pump, you can service it, but if it burns, it should only be replaced.
The cold of the radiator water
The problem can be related to a decrease in gas pressure, sedimentation of the converter, or failure of the heat sensor. There may also be a problem with the gas inlet and even the problem with the size of the gas pipe. What is the necessary action to repair the package in this regard? Remove the sediment from the converter, replace the heating sensor or the gas inlet valve. You can also replace the gas piping by legal means.
The water temperature consumed is low
It is possible that your converter is clogged. Your gas pressure has decreased or there is a problem with your hot water consumption sensor. What is the solution to this problem? Contact the gas office, descale the converter, check or change the hot water sensor.
Explosion
Another common and important problem of various types of wall-mounted packages is explosive ignition, which may not be suitable for your gas pressure. The problem is with the ignition electrode or the distance between the ignition electrode is not appropriate. If such problems occur, check your gas inlet and adjust it. Change the electrode and adjust its position by 3-5 mm.
Package off and turning on
If the package turns on and off continuously, it may be due to low water circulation in the heating circuit. Or the capacity and number of radiators are not enough. To solve this problem, you can solve your problem by opening the circuit valve more or increasing the number of radiators.
Excessive noise from the wall package
The seventh common problem of the wall package, which is of course very important, is excessive noise, which may be the problem of a malfunctioning rotor or air in your system. To solve the problem, you can change the rotor or ventilate it.