Installation of isogam
When installing Izogam, you should pay attention to some points and observe each of them so that you don't encounter any problems during its installation. The first point and thing that should be observed in the installation of Izogam is its temperature, which is at a low temperature and below 5 In any case, you should not try to perform isogam, because all the rubber properties of the rolling rolls will be lost below 5 degrees and it will also decrease sharply, which makes the connection between the surfaces with isogam to be done well. not to be destroyed, also you should not install Izogam in rainy weather. Don't forget to overlap the layers of insulation and do it for sure. For this, you need to take the edges together by 10 cm and isolate them completely. To ensure that it is stuck and secured, you need to seal the edge and end of the insulation. Heat it again and cover it with bitumen on the surface and stick it. But you must be careful that there should be no air between the surface and your insulation and ventilation should be done, which must be done by foot or hand pressure. Ventilate because the bubbles that remain under it can become a problem for you in the future
Install isogam on smooth surfaces
When installing Izogam on flat surfaces, you should pay attention to the following points: You must be careful when installing the abrou so that the sides of the abrou are in two layers and the insulation is placed 30 cm inside the abrou, and then you must be careful when welding the sides of the abrou because it is of great importance. Waterproofing Waterproofing Primer infrastructure Slope level Honor
Installation of isogam on Pi:
In installing Izogam, primer should be applied on the foundation surface, and after installation, complete insulation around the edges should be done with a special welding trowel. If you use asphalt for insulation, its temperature should not exceed 190 degrees Celsius. Concrete / Asphalt Waterproofing Isogam primer Concrete
Installation of isogam in the pool
Isogam installation in swimming pools must be done with concrete. At the beginning of the work, you must spread a layer of primer completely and evenly on the surface, and after it dries, install a layer of concrete with a thickness of 5 cm on the insulation. From it, the surface should be completely tiled or ceramic. Tiles / ceramics Concrete Waterproofing Waterproofing Concrete Muscularization
Installation of isogam on sloping surfaces and clay ceilings:
In the installation of isogam and insulation on sloping surfaces, it is usually covered with clay, which must be done after laying the insulation. pottery Waterproofing Primer infrastructure surface
Installation of isogam on the wall:
In order to install isogam and insulation on the wall, it is necessary to perform muscle building at the corner of the concrete wall to break the angle, which must be done at a 45 degree angle and the thickness of the insulation edge must be fixed at the end of the wall. Waterproofing Primer infrastructure Slope level Insulated edge holder Covering on the wall Muscularization
