Isogam is considered a resistant coating of bitumen and fibers that is used using heat on the bed of the desired location and glued. This insulation is used for isolation for different surfaces such as floor, roof, pools and building to prevent water and moisture penetration.
It should be noted that the life of high quality isogam is an average of 5 years. It is not bad to know, however, that until about 5 years ago, buildings were traditionally insulated using bitumen and asphalt. Even before that was used as a kind of insulation.
But do not forget that these products were not very resistant, and over time and the need to maintain capital and reduce energy consumption, they replaced insulators such as isogam that are more durable and durable. So what is the question of the isogam? We have replied.
But if we go back a little further, we find that the isogam was produced in Iran for the initial load about half a century ago, but it was since the production of isogam insulation in Iran. Iran faced a great leap. At this time, the city of Delijan emerged as a hub for the production of isogam insulation in the country.
The benefits of isogam
Tips to be observed in warehousing and maintenance
How to store moisture insulators is very important and the following points should be considered
. The selected place for warehousing should be completely smooth.
. Use completely cool places for warehousing, "2 to 2 degrees Celsius" and even shade.
. Rolls of moisture insulation stand together.
. Avoid putting insulators on a separately.
Tips to be observed when installing an isogam
To get the maximum efficiency of isogam moisture insulation, you need to follow the following tips exactly when installing:
. The surface should be smooth, clean and dry.
. The surface of the work should be dried with a bitumen primer and increased insulation adhesion to increase adhesion.
. The work surface should be completely sloping so that the water does not accumulate anywhere and directed to the drainage sites. "5% slope is recommended"
1. Installation of insulation should be done at temperatures above 2 ° C.
. Avoid installing insulation in an inappropriate environment "high humidity, rain, snow, etc.".
Important in selecting high quality isogam
1. Choose isogami that has at least the national standard of Iran.
. The isogam should consist of a double layer of Tishu and Polyester whose specifications are listed on the label.
. Choose isogam to suit the weather conditions of your area "tropical or cold" which is listed on the insulation.
. The isogam should be completely healthy, especially to the heel of the isogam roll that is not broken.
. Note that the isogam installation team do the utmost precision and elegance, always buy from reputable and reputable agencies, and remember to ask for a valid executive guarantee and insurance.
. Some manufacturers lower the weight of the isogam, so note the weight of the isogam not less than 37 kg.
. Choose two layers of powder isogam to insulate and must be first insulation.
. Winter isogam differs from the summer in terms of production formula. Note the date of production of isogam that has not been depot for more than 6 months.