Split (air conditioner) is one of the most commonly used cooling systems in homes and offices. However, like any other device, it may have technical problems. If you live in Shiraz or Jahrom and your Split needs repair, the Mawlai facility with its specialist team is ready to provide the highest quality Split repair services. In this article, we will examine 7 common Split problems and its solutions so that you can take action quickly in the event of any breakdown.

1. Split does not turn on (electric problem)

Symptoms: The device does not turn on at all. The internal or external panel lights are off.

Possible Reasons: ✅ Cut power supply (burnt fuse, defective outlet) ✅ Electronic board failure ✅ Problem in internal wiring

Solution: First, make sure the correct connection of the plug to the outlet. Check the power fuses. If the problem continues, contact the Mawlai facility repairers in Shiraz and Jahrom.

2. Split does not give cold (gas system or compressor failure)

Symptoms: The device is on but it does not produce cool air. The external panel gets hot

Possible Reasons: ✅ Refrigerated gas deficiency (Freon) ✅ leakage in copper pipes ✅ Compressor failure

Solution: If the gas is reduced, it must be recharged. In the event of a leak, the pipes must be repaired or replaced. Get help from the Mawlai facility to repair the compressor.

3. Declare water from Split (problem in condenser discharge)

Symptoms: Water dripping from the inner panel. The floor of the ground is soaked.

Possible Reasons: ✅ Incorrect installation of the device ✅ Discharge pump failure (in advanced models)

Solution: Clean the drain tube with air pressure or wire. Contact the Mawlai facility team if you need to repair or reinstall.

4. Unusual Split (fan or compressor failure)

Symptoms: sound, buzzing or whistling of the device. Possible Reasons: ✅ Broken fan bearings ✅ Shake of the external panel ✅ Compressor failure

Solution: Tighten the panel screws. If the fan is damaged, it should be replaced. Ask for specialized repair to help Mullah Installation Experts in Shiraz and Jahrom.

5. The smell of the splendt (filter or coil problem)

Symptoms: Unpleasant odor when the device is turned on. Possible Reasons: ✅ Dust and mushrooms in the filter Bacterial growth in coils

Solution: Clean the filters monthly. Use a disinfectant solution for coil washing. Contact us if you need a deep service.

6. Split works too low or high (the thermostat problem)

Symptoms: The device is constantly turned on and off. The ambient temperature does not remain constant. Possible Reasons: ✅ Thermostat not adjusting ✅ Temperature sensor failure

Solution: Set the thermostat to the appropriate temperature. Replace it in case of sensor failure.

7. High power consumption (difficulty in system performance)

Symptoms: The electricity bill has increased sharply. Possible Reasons: ✅ Dirty filters ✅ Inverter failure (in new models)

Solution: Do the periodic service. Get help from Mawlai facility to optimize energy consumption.

Conclusion

If your Split is in trouble in Shiraz or Jahrom, the Mawlai facility with its specialist team is ready to provide repair, installation and service service. 📞 Call now: ✅ Using original parts ✅ Fast and affordable service