How to prevent sedimentation of the wall package?
How to prevent sedimentation of the wall package? (Complete and practical guide to Latifi facilities in Rostamabad)
Deposition of the wall package is one of the most common reasons for decrease in efficiency, increase in gas consumption, drop in hot water pressure and failure of parts such as heat exchanger. By following a few simple but basic tips, you can multiply the life of the package and minimize the repair costs.
🔹 What is wall package deposition and why is it created?
Urban water contains salts such as calcium and magnesium. As the water inside the package heats up, these solutes sit on the walls of the heat exchanger, pipes and sensors in the form of deposits. In areas with high water hardness (such as many northern and central cities), this problem is more severe.
🔹 signs of package deposition
If you are experiencing any of the following symptoms, your package is probably contaminated:
✅ solutions to prevent wall package deposition
1️⃣ installation of polyphosphate sediment filter
One of the most effective and least expensive methods is installing a polyphosphate filter in the cold water inlet of the package. This filter prevents the settling of salts and is absolutely necessary for areas with hard water.
Advantages:
- Increasing the life of the heat exchanger
- Significant reduction of sediment
- Low installation and maintenance cost
2 regular periodic package services
Annual service (preferably before the start of the cold season) causes:
🔧 It is recommended that the service be performed by an authorized technician.
3 Setting the appropriate hot water temperature
Excessive water temperature accelerates the formation of sediment.
📌 Suggested temperature:
- Consumable water: 45 to 50 degrees Celsius
- Radiator heating: according to the size and environmental conditions
4 use of magnetic or electronic hardener
In buildings with high water hardness, using magnetic or electronic hardeners can be a good complementary option next to the polyphosphate filter.
5 Basic acid washing (if needed)
If the package is already severely fouled, acid washing of the heat exchanger is the only solution. This should:
- with a special device
- by an expert
- with standard materials
To be done so as not to damage the converter.
⚠️ common mistakes that cause precipitation
⭐ Summary
If you want your wall package:
- deteriorate later
- have uniform hot water
- have less gas consumption
Be sure to install a sediment filter, set the appropriate temperature and take periodic service seriously.
📞 Contact us for consultation, service and installation of wall-mounted sediment filter in Rostamabad city.
Latifi facilities - Rostamabad