It is based on the emulsion of the family of hydrocarbons based on thermoplast resins, which creates a product with adhesion and coating, and can be created as a membrane layer for coating tanks and drinking water pipes, protection of underground concrete structures and underground concrete structures and underground concrete structures. Also, protect the metal surfaces against corrosion.

Every 1 kg of this product can be used for 1 to 1.1 m 2 cover. However, this amount is increased depending on the current conditions and surface roughness. It is loose and if there are spots on the concrete surfaces, these areas should be corrected with the repair material and then the product with brushes or spray or rollers on the desired surface. To execute the second layer, one must wait 8 to 12 hours after the first stage, until the applied surface of the first layer to obtain the necessary adhesion to the second layer and the second layer perpendicular to the first layer, on the work surface. (If the concrete mortar applies to the second layer it is best to apply this layer coarsely by mixing some sand) when the drying time is between 5 and 35 degrees at maximum 8 to 12 hours and the full operation time is about 24 hours. This time Vary with the weather conditions of the area.

Incidents for sealing walls, ceilings, land, tunnels, refrigerators, pools, sanitary facilities, tanks, foundations, pottery and protection against chlorine ion penetration

If the primer is required under the work, this product can be diluted by 1 to 1 with water and executed as a primer. The material must be protected from frost before applying and hardness. It is not possible to apply on frozen surfaces. . The equipment can be cleaned with water before the material is hardened and used special thinners if it is hardened. This product is not resistant to negative water pressure.

The product is available in container 1, 4, 12, 20 and 220 kg.

The above product can be stored in standard warehouse conditions for 12 months.