Elevators are devices for moving between floors. To install an elevator, in addition to having enough skills of the technician, you need enough equipment and space. Some elevators operate hydraulically and some operate by traction. Setting up and installing elevators and selling lifts is one of the best collections.
Elevator installation steps
There are several steps to install an elevator. The first step is to draw the chassis. After the chassis is drawn, it is time to lay the rails. Once the rails are laid, the cabins should be placed, then the doors should be installed. They install the cabin itself. And in the last stage, the engine and the entire transmission system of the elevator is started.
Steps to install tensile elevator
Elevators have two models, hydraulic and traction, each of which requires special equipment for installation. In order to install a traction elevator or a normal elevator, it is necessary to create an elevator pit, an elevator room and a tunnel in which the elevator goes up and down. A tunnel is created inside the building for the elevator to go up and down, which is called an internal tunnel, and it can be installed outside the building as well. Indoor elevators go up and down with counterweights. Of course, in order to install elevators from outside the building, which are known as exterior elevators and go up and down with the weight of the balance, they need to install skeletonization. Usually, the hole that is installed for elevators is calculated from the lower level of the 120th elevator floor itself. In the upper part of the elevators, there is an elevator room, inside which the motor and the control circuit are placed.
Installation of hydraulic elevator
Hydraulic elevators are of two types, the first category is the elevators that have a jack from below, which is called a one-to-one system, and has two converters, and the other one is the Skopje. To install a hydraulic lift, one third of the floors of the building must be excavated so that the jack can be placed inside it, or the ground must be excavated as much as the entire floor of the building so that the jack can be placed inside. For example, if the two-story building is 6 meters, the ground should be dug up to the extent of 6 meters. Note that the power unit is placed both at the top and at the bottom. The speed of the hydraulic elevator is not higher than traction, but its power is more. And also its life and temperature are more.
Installation of elevator in old buildings
Installation of elevators in old buildings requires more care. Paying attention to sufficient space for installing elevators in old buildings is very important. Also, the technicians should carefully check whether this old building can install an elevator.
