Sahand hot oil pump and Tabriz pump are designed for pumping fluids that do not contain large particles but with very high temperature. Cooling in these types of pumps is done by air. The pump and the motor are directly coupled to each other and it enables easy installation and operation at the place of operation. For proper sealing and to ensure no leakage due to the dangers of the working fluid, two mechanical seals resistant to a temperature of 300 degrees Celsius have been used.
Flow rate: 5 to 350 cubic meters per hour Height: 150 meters Test pressure: 16 bar ✔️ In Sahand Industrial Group, Tabriz Pump produces all kinds of parts used in KSB pumps in Germany and Pumpiran, and customized pumps with specific uses made of steel, cast iron, bronze, etc., and all parts of industrial, agricultural, oil, petrochemical, and industrial machinery. Food and hygiene are also done.
Tabriz Pump Pump Supplies
Electric sludge pump In the Sahand sludge pump of Tabriz pump, the electric motor is 380 volt three-phase type. Due to the necessity of cooling the electric motor and preventing vibration, the electric pump should not be started in dry conditions, and it should be noted that there is no need for special conditions of the installation site to install these types of electric pumps, and it is easy to install the electric pump by placing it inside the desired fluid and installing it. Electrical connections and drain pipes can be used for fluid pumping.
Use cases Electric sludge pump is suitable for pumping liquids with solid particles and long fibers, sewage, polluted water, muddy water, etc. In these electric pumps, depending on the type of fluid to be pumped, a single-blade propeller or an open-sided propeller can be used.
Gearbox behind tractor Sahand pump The gearbox behind the tractor, increasing gearboxes with a conversion ratio of 1/3 (65 hp) and 4/1 (55 hp) or 1/6 (45 hp) to convert the output speed of the tractor to the required speed to start centrifugal pumps for use Drip irrigation or sewage transfer or WKL high pressure pumps are used for rain irrigation with high altitude and high pressure, as well as connection to the generator to generate electricity. The gearbox behind the tractor is installed at the end of the tractor and connected to the pump by a coupling. They go around.
